Toyota Avalon (XX50): Vsc Off Switch

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual / Brake / Brake Control / Dynamic Control Systems / Vsc Off Switch

Components

COMPONENTS

ILLUSTRATION

*1	COWL SIDE TRIM SUB-ASSEMBLY LH	*2	FRONT DOOR OPENING TRIM WEATHERSTRIP LH
*3	FRONT DOOR SCUFF PLATE LH	*4	HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
*5	INSTRUMENT SIDE PANEL LH	*6	NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
*7	NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY	*8	VSC OFF SWITCH

Inspection

INSPECTION

PROCEDURE

1. INSPECT VSC OFF SWITCH

(a) Make sure that there is no looseness at the locking part and the connecting part of the connector.

OK:

The connector is securely connected.

*a	Component without harness connected (VSC OFF switch)

(b) Disconnect the VSC OFF switch connector.

OK:

No deformation or corrosion.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
5 (+) - 2 (E)	Switch pushed	Below 1 Ω
5 (+) - 2 (E)	Switch not pushed	10 kΩ or higher

HINT:

If the result is not as specified, replace the VSC OFF switch.

Installation

INSTALLATION

PROCEDURE

1. INSTALL VSC OFF SWITCH

(a) Engage the 2 claws to install the VSC OFF switch to the No. 1 instrument panel sub-assembly.

2. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY

Click here

3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Click here

4. INSTALL INSTRUMENT SIDE PANEL LH

Click here

5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Click here

6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

Click here

8. INSTALL FRONT DOOR SCUFF PLATE LH

Click here

Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT DOOR SCUFF PLATE LH

Click here

2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

Click here

3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Click here

5. REMOVE INSTRUMENT SIDE PANEL LH

Click here

6. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Click here

7. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY

Click here

8. REMOVE VSC OFF SWITCH

(a) Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws to remove the VSC OFF switch from the No. 1 instrument panel sub-assembly.

*a	Protective Tape

Steering Angle Sensor

Brake Booster Pump(for Hv Model)

See More:

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Sfi System: HO2S Heater Control Bank 1 Sensor 1 Circuit Short to Battery (P003012,P003013,P005012,P005013,P101A9E,P103A9E)
DESCRIPTION Refer to DTC P219519. Click here HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the air fuel ratio sensor heater in fail-safe mode. Fail-safe mode continues until the engine switch is turned off. Although the DTC titles say oxygen sensor, these ...